Nov 15, 2024 PASS EMC D-PDC-DY-23 EXAM WITH UPDATED DUMPS
D-PDC-DY-23 Questions PDF [2024] Use Valid New dump to Clear Exam
NEW QUESTION # 28
Which value is used to determine the primary node role in a default VLT primary election?
- A. Highest system MAC address
- B. Highest management IP address
- C. Lowest management IP address
- D. Lowest system MAC address
Answer: A
NEW QUESTION # 29
Which of the following owns the VRRP group address to be used as the gateway for the hosts on the LAN?
- A. Primary router
- B. IP address owner
- C. VRRP router
- D. Backup router
Answer: A
NEW QUESTION # 30
What is a benefit of multicast over unicast and broadcast communication
- A. Bandwidth equally distributed to all devices
- B. Increase of the network load
- C. Latency is mitigated
- D. Minimum network bandwidth use
Answer: D
NEW QUESTION # 31
Which command shows whether a LAG protocol is static or dynamic on a Dell EMC Networking OS10 switch?
- A. show lacp neighbor
- B. show running-configuration lacp
- C. show port-channel summary
- D. show interface port-channel summary
Answer: C
NEW QUESTION # 32
What is the size of the VLAN tag in an Ethernet frame?
- A. 4 bytes
- B. 8 bytes
- C. 1 byte
- D. 2 bytes
Answer: A
NEW QUESTION # 33
To ensure that PIM traffic is not dropped by a router what command must be run?
- A. OS10 (config) # ip pim rp-address <IP address> group-address <group address>
- B. OS10 (config) # ip multicast cast-routing
- C. OS10 (config) # ip pim sparse-made
- D. OS10 (config) # ip multicast permit
Answer: C
NEW QUESTION # 34
What is the security impact of enabling LLDP?
- A. Login over telnet is permitted.
- B. Broadcasts toms are possible.
- C. Switch information is advertised.
- D. SNMP data is broadcasted on all ports
Answer: C
NEW QUESTION # 35
How does multicast traffic operate?
- A. Transmits TCP traffic to multiple receiving devices in a single data flow.
- B. Transmits UDP traffic to multiple receiving devices in multiple data flows.
- C. Transmits UDP traffic to multiple receiving devices in a single data flow.
- D. Receives UDP traffic from multiple sending devices in a single data flow.
Answer: C
NEW QUESTION # 36
What is an attribute of OS10 Enterprise Edition?
- A. Free download
- B. No license needed
- C. Provides a GUI
- D. Includes full programmability
Answer: D
NEW QUESTION # 37
Which two spanning-tree methods are supported by VLT on a Dell Z9284F-ON? (Select 2)
- A. MSTP
- B. RSTP-PV
- C. STP
- D. RSTP
Answer: A,D
NEW QUESTION # 38
Which statement is true regarding PTP7
- A. PTP leverages the BMCA (Best Master Clock Algorithm) to define the timing hierarchy.
- B. PTP synchronizes timekeeping among a set of distributed time servers and clients.
- C. Clients pull time from a server.
- D. PTP uses clock time zone command to synchronize servers and clients.
Answer: A
NEW QUESTION # 39
What is a valid OS10 default route configuration?
- A. S1(config-router)# ip route 0.0.0.0/32 interface ethernet 1/1/1
- B. S1(config)# ip route 0.0.0.0/0 interface ethernet 1/1/1
- C. S1(config-router)# ip route 0.0.0.0/0 144.254.32.1
- D. S1(config)# ip route 0.0.0.0 144.254.32.1
Answer: B
NEW QUESTION # 40
Which command is used to determine the VLT peer unit address?
- A. show running configuration vlt
- B. show vlt <Domain ID> role
- C. show vlt <Domain ID> detail
- D. show vlt <Domain ID>
Answer: C
NEW QUESTION # 41
What are Ihe three types of VHF instances? (Select 3)
- A. Standard
- B. Non-Default
- C. Native
- D. Default
- E. Management
Answer: E
NEW QUESTION # 42
In a Layer 3 Leaf-Spine topology what can be used to move Layer 2 traffic between racks?
- A. VLT
- B. VXLAN
- C. Port channel
- D. Trunks
Answer: B
NEW QUESTION # 43
In a VRRP configured environment without VLT, how does the backup VRRP peer respond to ARP requests?
- A. Responds to ARP requests with the MAC address of the virtual IP address
- B. Responds to ARP requests with the MAC address of the master peer's IP
- C. Does not respond to ARP requests
- D. Sends an ICMP redirect message
Answer: C
NEW QUESTION # 44
A network administrator has recently configured eBGP to use source addressing from its loopback interfaces. Customers later report that eBGP routes are not being learned.
What could be the cause of this issue?
- A. The network administrator neglected to issue the no shutdown command to bring the loopback interface online
- B. BGPv4 does not support the use of loopback interfaces
- C. BGP devices must be configured to use source addressing from its physical interfaces only
- D. BGP devices must be configured with the multihop command when using loopback interfaces
Answer: D
NEW QUESTION # 45
......
D-PDC-DY-23 Study Guide Brilliant D-PDC-DY-23 Exam Dumps PDF: https://troytec.getvalidtest.com/D-PDC-DY-23-brain-dumps.html